Electrician Emergency Pro Toronto · 24/7

EV charger installation in Midtown Toronto

Level 2 home chargers for houses and garages in Forest Hill, Deer Park, Rosedale and the Annex, installed on a properly sized circuit after a load check, with fast help if a charger or its circuit fails.

Load check first

A Level 2 charger needs a dedicated 240 volt circuit, usually 40 to 60 amps. Before recommending a charger or a circuit size, we add up what your panel already carries. If there is room, we install a dedicated circuit. If capacity is tight, an EV energy management system can pause or slow charging when the rest of the house is busy. If there is no room at all, the charger is planned together with a panel upgrade.

Garages, drives and older lots

Forest Hill and Rosedale homes often have attached or detached garages with long runs from the panel, while Annex and Deer Park houses may have tight side drives or laneway garages. We plan the cable route, use outdoor-rated equipment where the charger is outside, and mount it where the cable reaches the car without crossing a walkway.

When a charger stops working

If a charger keeps tripping its breaker, shows a fault or the circuit feels warm, stop charging and call us. We check the circuit, the connections and the breaker, and repair or replace what is needed so you are charging again quickly.

We install Tesla Wall Connector, ChargePoint, Grizzl-E, FLO and other major brands, hardwired for daily use, under an ESA permit and inspection.

How an EV charger install goes

  1. Send photos. Your panel, your parking spot and the charger model if you have one.
  2. Load check. We confirm capacity and choose a direct circuit, load management or an upgrade.
  3. Install. Circuit, cable run and charger mounted, usually in one visit when the panel is near the parking spot.
  4. Test. The charger’s current is set to match the breaker and tested with your car where possible.

EV charger questions

Can my panel handle a Level 2 charger?

Often, yes, especially with load management. The load calculation tells us for sure.

My charger keeps tripping the breaker. Is that dangerous?

Repeated tripping means something is wrong: the circuit may be undersized, a connection may be loose or the charger may have a fault. Stop using it and call us to check it.

Can two EVs share one circuit?

Chargers that support power sharing can split one circuit between two cars and balance the current automatically.

Do I need a permit?

Yes. EV charger circuits in Ontario need an ESA permit and inspection, which is part of the job.