Electrician Emergency Pro Toronto · 24/7

Pot light installation in Midtown Toronto

Slim LED pot lights for living rooms, kitchens, basements and soffits in Yorkville, the Annex, Deer Park and Forest Hill, laid out for each room and installed cleanly, plus quick fixes when lights flicker or die.

Planned for the room

We plan lighting around how each room is used: perimeter layouts that wash the walls in living rooms, lights lined up over counters in kitchens, and even coverage in basements. Every location is marked and agreed on with you before we cut, and each zone gets its own LED-rated dimmer.

  • 2700K to 3000K for warm living spaces
  • 3500K to 4000K for kitchens and work areas
  • Wet-rated fixtures over showers and tubs
  • Soffit lights on timers or photocells

Older ceilings and condo suites

Plaster and lath ceilings in the Annex and Deer Park need careful cutting to avoid cracks. Concrete ceilings in Yorkville condos cannot take recessed lights, so there we use slim surface-mount fixtures or pendants. Lights under an attic are IC-rated and airtight so they can sit in insulation without leaking heat.

Flickering or dead pot lights

Flicker, buzzing or lights that cut out are usually caused by an incompatible dimmer, a failing LED driver or a loose connection. We trace the cause and fix it, often in a single visit, and replace old halogen fixtures with LEDs that run cooler and use far less power.

How a pot light job goes

  1. Photos. Send photos of the room and what you have in mind.
  2. Layout. We mark lights, switches and dimmers with you on site.
  3. Install. Most rooms take a day or less, and we clean up before we leave.
  4. Test. Every zone and dimmer tested together.

Pot light questions

Why do my LED pot lights flicker?

Usually the dimmer is not rated for LEDs, or a driver is failing. Swapping to a compatible dimmer or replacing the driver normally fixes it.

Can pot lights go in a condo ceiling?

Not recessed into solid concrete. Slim surface-mount LED fixtures give a similar clean look.

How far apart should they be?

Four to six feet apart is a common starting point, adjusted to the room and ceiling height.

Do you install soffit lights?

Yes, including timers, photocells or smart switches to control them.